Recent content by paddy1000111

Correct me if I'm wrong here but is this not the cable that goes to the O/S/F jump point/fuse box in which case it only passes through that area? I've just had a look at diagrams and my own car and there's no terminal in that area from what I can see. I think the bracket that it runs under is...

Enable the developer settings on the phone and find the Bluetooth PBAP settings which is for the phonebook. Set it up as below. This work for me as my phone kept disconnecting, the phonebook wasn't working and music kept cutting out etc.

My first tip would be to mix up some washing up liquid in a spray bottle and then put the cabin blowers on full with everything closed and then go around spraying all the seals. If you have an air leak big enough to pull exhaust into the car then you will see/hear it from a mile off with that...

I believe the piezo electrical units on these crack and then when they're hot the crack opens causing failure, they cool and the crack closes making them work again. Could test that theory with a can of freezer spray I suppose. In terms of carbon cleaning I'm giving a tank of V-power a go...

Hi all, I had a rib tear off my 4 month old aux belt and slap it's way around the engine. Since then I've noticed that when in Neutral and stopped the idle causes the car to gently rock, that's with the AC off etc and there's no notible engine noise change. It feels as though it's missing at...

Hi All, Long story short I haven't had time to fit the pre-cut clear PPF kit I bought a couple months back for my 2016 V6S so I am putting it up for sale. It's the kit supplied from Aliath (made from oraguard), all the parts are still available on their site should you want to get more parts...

Looks good! If you fancy giving ceramic coating a go I can highly reccomend carpro cquartz UK 3.0 as its easy to apply and seems to last for me!

If you fancy a bit of messing around you can get the ctek battery panel and if it in the boot for an easy quick connect!

Been doing the same. 99% paint correction before PPF application next week. I've had a tonne of stone chips since I purchased it in July last year!

Just topped off my ceramic coating this weekend with autobrite Carbanuba. Ceramic coatings are fantastic for protection but for depth and gloss I just don't think you can beat a proper old fashioned wax. Don't bother with dealers. Go to a pro or do it yourself if you want to learn something...

Hi all, I've got a couple of quotes for PPF and the figure is eye watering. I'm basically trying to protect it from stone chips on the sills. I get that PPF isn't cheap but has anyone purchased a pre-cut kit? Plenty of companies making kits and considering I install it on planes in my job, I...

Apologies if this is in the wrong section but I didn't see a for sale area. I have 2 Pirelli P-zero tyres in 255/35R20 97Y for sale. Only fitted last year the lowest measurement I can find on them is 7.27mm so they still have a tonne of life left. Even wear across the tread with a deviation of...

Hi all, I have a 2016 v6s and my exhaust valves suffered the usual failure. Had it checked by the independent whilst it was in for other work and they confirmed the issue as irreparable. I did some googling and came across mod_stock on the forum but didn't find any specific review. There are...

Hi all, Went away for work and came back tonight to find a puddle under the drivers side wheel. I parked the car on a slope with the front lower than the back. When I started it I was also met with the message that the wiper fluid is low. I assume that the windscreen washer anti-syphon valve in...

Hi All, Just got my car back from the specialist after having the water pump changed as it was leaking. I asked him to take a look at the supercharger pulley as I could hear a little rattle and he has confirmed the supercharger coupler has failed (spring no longer tight). It's a 2016 V6S with...